Author Topic: Bavaria 36 Jib furling line  (Read 1255 times)

MacLovin

  • Cadet
  • *
  • Posts: 6
  • Karma: +0/-0
  • Boat Model: 36
  • Boat Year: 2003
Bavaria 36 Jib furling line
« on: October 10 2024, 17:43 »
Where the heck is the jib furling line supposed to run?
I have a 2003 Bavaria 36.
There is one block attached at the pulpit, then the fairlead and cleat aft of the winch.
Where should it go in-between?
Thanks in advance.

symphony2

  • Old Salt
  • *****
  • Posts: 517
  • Karma: +11/-0
  • Boat Model: B33
  • Boat Year: 2015
Re: Bavaria 36 Jib furling line
« Reply #1 on: October 10 2024, 19:18 »
it runs through a slot in the stanchion base. Works OK but better to use stanchion fairleads from Harken, Selden, Spinlock, Barton etc.

Keweetoo

  • First Mate
  • ***
  • Posts: 69
  • Karma: +2/-0
  • Boat Model: Bavaria 35E
  • Boat Year: 1999
Re: Bavaria 36 Jib furling line
« Reply #2 on: October 12 2024, 12:21 »
I found running the furling line through the stanchion base slots produced a lot of friction and dirt on the line. Fitting stanchion fairleads 100mm up was much better together with a cam cleat/right angle block aft.