« previous next »
Pages: [1]   Go Down

Author Topic: Is this a sign that the injector seal is gone?  (Read 1579 times)

marioxp

  • Old Salt
  • *****
  • Posts: 202
  • Karma: +1/-2
  • Boat Model: Bavaria 36
  • Boat Year: 2003
Is this a sign that the injector seal is gone?
« on: May 31 2022, 11:16 »
I noticed that bubbles are forming around the injector. And the diesel leaks slightly around the injector.

Is this a sign that the injector seal is gone or the injector itself.

The engine is MD2030 and has 3.400 operating hours.

Best regards,

Mario
Logged

Krumelur

  • Old Salt
  • *****
  • Posts: 317
  • Karma: +2/-3
  • Boat Model: Bavaria 40
  • Boat Year: 2010
Re: Is this a sign that the injector seal is gone?
« Reply #1 on: May 31 2022, 11:37 »
Have you checked where the fuel is coming from?
In the video there's liquid at the top and the bottom (arrows).
Is the Diesel at the base dripping down and just bubbling because the engine is vibrating and it's actually coming from the top part of the injector?

Logged

marioxp

  • Old Salt
  • *****
  • Posts: 202
  • Karma: +1/-2
  • Boat Model: Bavaria 36
  • Boat Year: 2003
Re: Is this a sign that the injector seal is gone?
« Reply #2 on: May 31 2022, 11:42 »
I can confirm that I also saw diesel on the top of injector.

I can't tell if it's leaking from the bottom too.
Logged

Krumelur

  • Old Salt
  • *****
  • Posts: 317
  • Karma: +2/-3
  • Boat Model: Bavaria 40
  • Boat Year: 2010
Re: Is this a sign that the injector seal is gone?
« Reply #3 on: June 02 2022, 10:03 »
I think you’d have to figure out where it’s coming from before
 further steps. But it’s certainly leaking at the top, so that’s what needs to be fixed in any case.
Logged

diverphil

  • Able Seaman
  • ****
  • Posts: 137
  • Karma: +1/-1
  • Boat Model: 33 cruiser
  • Boat Year: 2006
Re: Is this a sign that the injector seal is gone?
« Reply #4 on: June 02 2022, 20:11 »
the part with the pipe on is the return, (leak off pipe) check its not coming from the joint between the pipe and the injector, usually sealed with copper washers but sometimes aluminium washers are used, the ally corrodes and you get a leak.
Logged

nightowle

  • Able Seaman
  • ****
  • Posts: 141
  • Karma: +1/-0
  • S/V In Deep - 1999 Bavaria 35E
  • Boat Model: 35 Exclusive
  • Boat Year: 1999
Re: Is this a sign that the injector seal is gone?
« Reply #5 on: June 04 2022, 08:29 »
Is it possible to just tighten up each of the nuts on the injector to see if that stops any leaking?  Do they need tightening to a specific spec?
Logged
S/V In Deep - 1999 Bavaria 35E
Seattle, WA USA
Pages: [1]   Go Up
« previous next »