Bavaria Yacht Info
Member Forums => Bavaria Yacht Help! => Topic started by: diverphil on July 04 2021, 13:08
-
Help. Our fridge just stopped working. I've checked the 12v supply and its ok. Have put an led to test between small + and D terminals as per danfos diagnostic site but I didn't get any blink code.
Also put a link across c & t terminals to take the thermostat out of the system, should run permanently to do the test. But nothing runs. Any ideas?
-
No diagnostic LED and no action in presence of good power supply means the fridge controller has died.
If your compressor is a Danfoss/Secop (most of the rebadged boat friges from Weco, Frigoboat, Penguin, etc. are), then this is the unit you need: https://www.ebay.co.uk/itm/273083414314
-
unit is weaco, compressor is danfos, will get hold of one, hoping it fixes it as we are on boat in 2 weeks, but cant get down before.
thanks
phil
-
Phil, if your boat is still at Conwy Marina, there is a firm of refrigeration engineers, J.D. Refrigeration based at Conwy Road, Mochdre if your system needs re-gassing.
-
Boat is at pwlhelli for this year. Are there any fridge engineers down there.(that would go to a boat if req)
-
Only just seen this . It is worth taking a separate supply via croc clips direct from the battery if a fridge fails to start . On my fridge the electronic low volt disconnect was fast enough to not show on a voltmeter , the multiconnector in the electrics cupboard was corroded. Geoff
-
Tried all the tests etc. Put a new control on last Sunday all seems to be working again.
Thanks for the advice
Phil.