Bavaria Yacht Info

Member Forums => Bavaria Yacht Help! => Topic started by: Mattias on March 24 2021, 17:29

Title: German mainsheet?
Post by: Mattias on March 24 2021, 17:29

Hi,
I would like to upgrade my B43 Cr to singel-handed. How shall then the mainsheet run from the bom to be controled by helmsman? Are there any instructions/manuals/guides or a scheme over the mainsheet run somewhere?

Title: Re: German mainsheet?
Post by: Mattias on March 24 2021, 17:49

Yes!
Found it but in Swedish.
http://www.sybluebird.se/default.htm?turl=Documents%2Ftyskskotning.htm

Title: Re: German mainsheet?
Post by: catlotion on March 28 2021, 21:05

I'm interested in doing this too.  That description looked like it used the primary winches though.  What do they do with the jib/Genoa sheets?

Title: Re: German mainsheet?
Post by: SYJetzt on March 29 2021, 08:09

It seems they use the optional spi winches, which is a great idea. I will check this on our boat as soon i'm back on board again!

Title: Re: German mainsheet?
Post by: Yngmar on March 29 2021, 18:25

I wouldn't be very keen on drilling holes into my chainplates as shown in the linked article and putting considerable loads on them in a direction they're not designed to take it in. Nor would I trust an eye bolt without a load rating to take mainsheet loads, especially as it's getting loaded at a ~45 degree angle. Bit dodgy solution to say the least! :o