« previous next »
Pages: [1]   Go Down

Author Topic: volvo Penta Easy Connect Interface on D2 MDI  (Read 1612 times)

Sunharvester

  • First Mate
  • ***
  • Posts: 55
  • Karma: +0/-1
  • Boat Model: Vision 46
  • Boat Year: 2016
volvo Penta Easy Connect Interface on D2 MDI
« on: June 28 2022, 21:18 »
Anyone have experience connecting thi interface to an MDI

Drawing suggest just connecting to the nmea2000 network but I'm not sure the mdo is connected to the network. Boat is a Vision model.

Any insight super appreciated!
Logged

reystos

  • Second Mate
  • **
  • Posts: 28
  • Karma: +0/-0
  • Boat Model: Bavaria 31
  • Boat Year: 2000
Re: volvo Penta Easy Connect Interface on D2 MDI
« Reply #1 on: June 29 2022, 09:29 »
Documentation suggests that the Volvo MDI speaks a type of J1939.
If I was to guess, the Easy Connect Interface acts as a translator between NMEA2000 and Volvo's native protocol. So that you can include sensors that use nmea2000.

There is a Y harness adapter that should allow you to put it on the same harness branch as your rpm gauge.
Logged

SYJetzt

  • Old Salt
  • *****
  • Posts: 320
  • Karma: +11/-0
  • Boat Model: Cruiser 46
  • Boat Year: 2005
Re: volvo Penta Easy Connect Interface on D2 MDI
« Reply #2 on: June 29 2022, 16:55 »
If you want to see your engine data on your plotter, there are much cheaper solutions than the original VP stuff. https://www.yachtd.com/products/engine_gateway_gallery.html
Logged
Pages: [1]   Go Up
« previous next »