I would like to mount wind vane steering on my Bavaria 32 cruiser for long distance cruising.
It has the wide swim platform and I think it is not practical to mount an offset wind vane; with the wide transom, the rudder would be pulled out of the water.
I don't think it is practical to mount a single side offset frame, as the offset would be too big and would not be strong enough.
I think the only solution would be to build a big frame across the stern consisting of two solid removable tubes then hang the wind vane steering off that. When I was coastal or inter-island cruising I would take it off. For long crossings, I would sacrifice the swim platform (which is unusable anyway).
Has anyone done a similar mod or had similar ideas?
I also find the front anchor locker ridiculously small. With 50m of chain in it, it is completely full. To add a warp, I would have to store it on deck or somehow shackle it on to the chain after having dropped the chain part and pulled the chain out of the Quick winch (not very practical to take back up one stormy night).
I have considered sacrificing the front cabin and cutting it partly into storage and a big anchor locker. Has anyone done this?
I would also like to add a stern chain locker in the over-spacious rear port storage. The Bavaria 32 also has, annoyingly, only one on deck storage space for a gas bottle. I would also like at the same time to add storage for a second bottle.
I can see someone saying, sell your Bavaria 32 and buy a different boat. That would be a reasonable but not a constructive comment.